ตัวกรองผลการค้นหา
stunt end, form stop, stop end, say joint
แปลว่ารอยหยุดตั้งฉากในการเทคอนกรีต
joint connecting the two shells of a pearl oyster
แปลว่าขื่อมุก
R
แปลว่าสัญลักษณ์หรืออักษรย่อของคำว่า Resistance (ความต้าน) Ratio of expansion (อัตราของการขยายตัว), Radius (รังสี)
Sulfate Attack
แปลว่า(Concrete Engineering) Deleterious chemical and/or physical re-action between sulfates in ground water or soil and certain constituents in cement, which result in expansion and disruption of the concrete.
Blister 2
แปลว่า(english) A defect in metal, on or near the surface, resulting from the expansion of gas in a subsurface zone. Very small blisters are called pinheads or pepper blisters.
Spall
แปลว่า(Concrete Engineering) A fragment, usually of flaky shape, detached from a larger mass by pressure, expansion from within the larger mass, a blow, or by the action of weather.
ASR - Alkali-Silica Reactivity
แปลว่า(Concrete Engineering) The reaction of aggregates, which contain some form of silica or carbonates with sodium oxides or potassium oxides in cement, particularly in warm, moist climates or environments, causing expansion, cracking or popouts in concrete.
Bearing Strength
แปลว่า(english) The maximum bearing load at failure divided by the effective bearing area. In a pinned or riveted joint, the iffective area is calculated as the product of the diameter of the hole and the thickness of the bearing member.
Blister
แปลว่า(english) 1) Coating defect consisting of the formation of bubbles in a coating, which appear as hemispherical elevations. The blisters are hollow, and are usually caused by entrapped air or solvent. 2) A raised spot on the surface on the surface of metal due to expansion of gas which causes a subsurface metal separation such as inclusions and small laminations.
Bent Axis Pumps
แปลว่า(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.
